winding of shapers:
– Winding of shapers (e.g. angle bars, channel bars, flat bars) and tubes for rings. The diameter of winding: 350-6000 mm (depending on the shaper’s section).
– pressing, hydraulic presses: push of 300T, the surface of the table 1200×1200 mm, the highest slide leap 1000 mm
– pressing, hydraulic presses: push of 250T, the surface of the table 900×630 mm, the highest slide leap 500 mm

sheet metal winding, small rollers:
– minimum diameter 200 mm
– maximum length 1200 mm
– thickness of the material 5 mm

sheet metal winding, big rollers:
– minimum diameter 600 mm
– maximum length 3000 mm
– thickness of the material 12 mm

winding of cones, mechanical spinning:
– spinning of dished head and elliptic bottom: diameter from 400 to 1500 mm, made of carbon steel – thickness 3-4 mm, – made of high-ally steel – thickness 3 mm
– bordere spinning of flat head and cone bottom: diameter 600-4000 mm, thickness of the material fom 4 to 12 mm

We produce bottoms:
– for waste removal tankers – diameters: 1000, 1100, 1200, 1300 mm
– for boilers and heat exchanger